Reaching Others University at Buffalo - The State University of New York
Skip to Content

Using TurningPoint AnyWhere in a clicker-ready classroom

Use clickers with any application in a clicker-ready classroom.

Using Any Application With Clckers

  1. Bring your presentation and participant file to your classroom.
  2. Move these files to the desktop in your classroom.
    • If you are not in a technology classroom, you need to make sure the software is installed and the receiver is plugged in.
  3. Open the TurningPoint AnyWhere software and a question list if you have one.
  4. Open your presentation.
  5. Load your participant list.
  6. Log in to ResponseWare.
  7. Reset your session.
  8. Run your presentation.
  9. Save your session (we recommend you save to a jump drive).
  10. Run your report when you return to your office.

Was this information helpful?

 
 
 
 
 
 
(Required)
Enter both words below, separated by a space. If either word appears unclear, click 'Get a new challenge' to receive two new words.